7/23/2023 0 Comments Piezo preamp schematic![]() I want to make sure I have loads of clean headroom, so anything that will help that. Is there anything else I need to do to the basic b15n preamp circuit to better work with a peizo?ĥ. Here is a pic of the small trans that I will be using (tranny on the left):ģ. Rectifier – I want to use a tube rectifier, but I am not sure if the tranny I am using will let me, or what rectifier tube to use. Should I match that, or should I got with something like a 4.7m input resistor like a lot of the peizo preamps I see online.Ģ. Input Resistor – the pickups input resistance is 1m per channel. I will have a separate notch for each channel that is switched with a small micro switch.ġ. So I want to do a notch filter on each channel that drops 100hz, but leaves everything above about 120hz and below 80hz. Also, when playing at louder volumes, or when the acoustics of a room are terrible, my bass feedsback at about 100hz. I want to make the preamp circuits as close as possible to the original B15n but obviously setup for a piezo. It will have separate volume, treble, and bass controls for each channel, and I will use push/pull tone pots for the bass and treble boost. My bass has a stereo jack on it, so the preamp will have a single stereo input. What I want to build is an Ampeg b15n based dual channel preamp that I can use to plug into house sound, my regular bass amp, or use to record direct. It came with a preamp that sounded so bad I literally threw it away. I play an upright bass that has a dual piezo pickup. I am on vacation for a week and I am starting to plan my next build.
0 Comments
Leave a Reply. |